ALUMINUM ELECTROLYTIC CAPACITORS 鋁電解電容器
CN
Series
CHIP TYPE, NON-POLARIZED
貼片式,無極性品
Non-polarized with general temperature +85°C 無極性和適用於 +85°C的常規溫度 Load life of 1000 hours 負荷壽命1000小時
RoHS & REACH compliant, Halogen-free 符合RoHS與REACH,無鹵
SPECIFICATIONS 特性表
Items 項目
Operation Temperature Range 使用温度範圍Voltage Range 額定工作電壓範圍 Capacitance Range 靜電容量範圍 Capacitance Tolerance 靜電容量允許偏差 Leakage Current 漏電流
Dissipation Factor (tan δ) 損耗角正切
-40 ~ +85°C 6.3 ~ 50V 0.1 ~ 100μF
±20% at 120Hz, 20°C
Leakage current ≤0.05CV or 10μA, whichever is greater (after 2 minutes application of rated voltage at 20°C) 漏電流 ≤0.05CV或10μA,取較大值(在20°C環境中施加額定工作電壓2分鐘後) C: Nominal capacitance (μF) 標稱靜電容量, V: Rated voltage (V) 額定電壓
Measurement frequency 測試頻率: 120Hz, Temperature 温度: 20°C Rated Voltage (V) 額定工作電壓6.3 10 16, 25 35, 50 tan δ (max.) 最大損耗角正切 0.24 0.20 0.17 0.15 Measurement frequency 測試頻率: 120Hz
Rated Voltage (V) 額定工作電壓 6.3 10 16, 25 35, 50
3 2 2 4Impedance Ratio 阻抗比Z(-25°C) / Z(20°C)
Z(-40°C) / Z(20°C)8 6 4 3 ZT/Z20 (max.) After 1000 hours application of the rated voltage at 85°C (the polarity needs to exchange every 250 hours), they meet
the characteristics listed below.
在85°C環境中施加額定工作電壓1000小時(每250小時必須轉換一次極性)後,電容器的特性符合下表的要求。 Capacitance Change 靜電容量變化率 Within ±20% of initial value 初始值的±20%以內 Dissipation Factor 損耗角正切 200% or less of initial specified value 不大於規範值的200% Leakage Current 漏電流 initial specified value or less 不大於規範值
After leaving capacitors under no load at 85°C for 1000 hours, they meet the specified value for load life characteristics listed above.在85°C環境中無負荷放置1000小時後,電容器的特性符合高溫負荷特性中所列的規定值。 After reflow soldering and restored at room temperature, they meet the characteristics listed below. 經過回流焊並冷卻至室溫後,電容器的特性符合下表的要求。
Capacitance Change 靜電容量變化率 Within ±10% of initial value 初始值的±10%以内 Dissipation Factor 損耗角正切 initial specified value or less 不大於規範值 Leakage Current 漏電流 initial specified value or less 不大於規範值 Black print on the case top. 鋁殼頂部黑字印刷。
Characteristics 主要特性
Stability at Low Temperature
低溫特性
Load Life 高溫負荷特性
Shelf Life 高溫貯存特性
Resistance to Soldering Heat 耐焊接熱特性
(Please refer page 23 for soldering conditions) (焊接條件請查閱第23頁)
Marking 標識
DRAWING 外形圖 (Unit: mm)
*1 Voltage 電壓 Series 系列名 0.3 Max. C±0.2 { +0.4 –0.1 L L±0.4*2 0.5~0.8 {Negative 負極
*1. Voltage mark for 6.3V is [6V] *2. Applicable to ∅6.3×7.7 6.3V的產品標識為 [6V] 適用於∅6.3×7.7
DIMENSIONS (Unit: mm) 尺寸表
∅D x L A B C
4 x 5.4
5 x 5.4
6.3 x 5.4
6.3 x 7.7
E ± 0.2 L
2.0 2.2 2.6 2.6 4.3 5.3 6.6 6.6 4.3 5.3 6.6 6.6 1.0 1.4 1.9 1.9 5.4 5.4 5.4 7.7 Note: All design and specifications are for reference only and is subject to change without prior notice. If any doubt about safety for your application, please contact us immediately for technical assistance before purchase.
注: 以上所提供的設計及特性參數僅供參考,任何修改不作預先通知。如果在使用上有疑問,請在採購前與我們聯繫,以便提供技術上的協助。
东莞市合粤电子有限公司
A±0.2 E A±0.2 ∅D±0.5 ⊕B±0.2 1016V0.5 Max. Capacitance 靜電容量 Plastic platform 底座 ⊕Positive 正極
www.heyuecap.com
ALUMINUM ELECTROLYTIC CAPACITORS 鋁電解電容器
WV Code μF 代碼 0.1 0.22 0.33 0.47 1 2.2 3.3 4.7 10 22 33 47 100 0R1 R22 R33 R47 010 2R2 3R3 4R7 100 220 330 470 101
6.3 0J 10 1A 16 1C 25 1E 35 1V 50 1H DIMENSIONS & MAXIMUM PERMISSIBLE RIPPLE CURRENT 規格尺寸及最大允許紋波電流
4 × 5.4 1.0 4 × 5.4 2.0 4 × 5.4 2.8 4 × 5.4 4.0 4 × 5.4 8.4 4 × 5.4 8.4 5 × 5.4 13 5 × 5.4 6.3 × 5.4 6.3 × 5.4 6.3 × 7.7 28 37 45 82 4 × 5.4 6.3 × 5.4 6.3 × 5.4 6.3 × 7.7 6.3 × 7.7 17 33 41 61 85 4 × 5.4 5 × 5.4 6.3 × 5.46.3 × 5.46.3 × 7.7 12 23 37 49 75 5 × 5.4 5 × 5.4 6.3 × 5.46.3 × 7.76.3 × 7.7 12 16 27 50 61 5 × 5.4 5 × 5.4 6.3 × 5.4 6.3 × 7.7 16 18 29 54 5 × 5.4 6.3 × 5.46.3 × 7.7 Case size尺寸 17 20 36 Ripple current紋波電流yCase size ∅D×L(mm), ripple current (mA rms) at 85°C, 120Hz y尺寸∅D×L(mm),紋波電流(mA rms)於85°C, 120Hz
FREQUENCY COEFFICIENT OF ALLOWABLE RIPPLE CURRENT 紋波電流頻率補償系數
Frequency 頻率 Coefficient 系數
50Hz 0.70
120Hz 1.00
300Hz 1.17
1KHz 1.36
10KHz~ 1.50
The endurance of capacitors is reduced with internal heating produced by ripple current at the rate of halving the lifetime with every 5~10°C rise. When long life performance is required in actual use, the rms ripple current has to be reduced. 鋁電解電容器在疊加紋波電流後會引起發熱,溫度每上升5~10°C壽命會減半。若要保持長壽命性能,請在使用過程中適當降低紋波電流。 Note: All design and specifications are for reference only and is subject to change without prior notice. If any doubt about safety for your application, please contact us immediately for technical assistance before purchase.
注: 以上所提供的設計及特性參數僅供參考,任何修改不作預先通知。如果在使用上有疑問,請在採購前與我們聯繫,以便提供技術上的協助。
东莞市合粤电子有限公司www.heyuecap.com
因篇幅问题不能全部显示,请点此查看更多更全内容